Enzo v2.0 documentation

Enzo Internal Unit SystemΒΆ

The units of the physical quantities used in Enzo depend on the problem being run. For most test problems there is no physical length or time specified, so the units can be be simply scaled. For cosmology, there are a set of units designed to make most quantities of order unity so that single precision floating-point variables can be used. These units are defined in EnzoOutputFormat. Additionally, discussion of how particle masses are stored in Enzo can be found at EnzoParticleMass. However, with the broader use of Enzo for non-cosmological astrophysics applications, it has become necessary to add a new set of units into the code. This page describes how to set these units.

In order to have a self-consistent set of units, the user has to set appropriate length, time, and mass OR density scales. Simulations that include gravity also need to have a self-consistent gravitational constant that is scaled to the other variables. The four parameters that the user can set are LengthUnits, TimeUnits, DensityUnits, and MassUnits. Only one of DensityUnits or MassUnits needs to be set, since MassUnits = DensityUnits \* LengthUnits\ :sup:`3`\ . Additionally, if the parameter SelfGravity is turned on (set to 1), the parameter GravitationalConstant must be set to 4*pi*G, where G is Newton’s gravitational constant as a dimensionless quantity (that is, with all units scaled out).

The primary motivation for using a non-arbitrary set of units is to take advantage of Enzo’s various chemistry and cooling algorithms, some of which have been scaled assuming CGS units. To do this, one chooses physical units assuming the simulation box size is unity in code units, and that a density/mass and time value of 1 in code units are something meaningful in CGS. For example, if one is interested in setting the box size to one parsec, a density of 1 in code units equivalent to to 10 hydrogen atoms per cubic centimeter (in CGS units), and the time unit to one million years, the appropriate settings of the parameters would be as follows:

DensityUnits = 1.67e-23    # 10 hydrogen atoms per cc in CGS (c/cm^3)
LengthUnits = 3.0857e+18   # one parsec in cm
TimeUnits = 3.1557e+13     # one megayear in seconds

If we then wish to use gravity, the gravitational constant must be set explicitly to 4*pi*G expressed in a unitless fashion. Since the gravitational constant in CGS has units of cm3/(g*s2), this means that the value should be 4*pi*G_{cgs}*``DensityUnits``*``TimeUnits``2. So, in the units expressed above, that means the gravity parameters must be set as follows:

SelfGravity                = 1
GravitationalConstant      = 0.0139394         # 4*pi*G_{cgs}*DensityUnits*TimeUnits^2

Note that if gravity is turned on, the parameter TopGridGravityBoundary must also be set to either 0 (periodic) or 1 (isolated).

If you set only LengthUnits and DensityUnits but not TimeUnits the code will calculate it for you using the actual gravitational constant. You see it printed out in the terminal when the code starts up and you can also find it towards the end of the parameter file of any output.